Craig Curk – Instructions For Re-gripping A Golf Club

As an experienced golfer, Craig Curk often needs to re-grip his clubs, especially as they start to show signs of wear and tear after prolonged use. This is a process that many golfers are unfamiliar with, so if you think your club needs re-gripping try to keep all of the below pointers in mind.

Craig Curk

Clean and Vice

Before your start handling the grip on the club, you should clean the area around it and then place the club in a vice. It is a good idea to place some rubber grips inside the vice, as this will provide a little bit of give when working on the club, which should prevent you from accidentally bending the club itself.

Removed The Old Grip

Make use of a utility knife to cut down the length of the grip, lightly cutting the tape. However, make sure that you don’t cut too deeply as you may end up shearing through the tape underneath and into the club. Once you have made the cut, pull it with your fingers and you should find that the grip pulls off fairly easily. If you’re having trouble, consider using a liquid solvent to make the process a little easier.

Placing The New Grip

Craig Curk has replaced a number of club grips. Wrap the relevant area of the club in double-sided tape and cover both that and the inside of the new grip in liquid solvent. Use a golf tee to plug the hole at the end of the grip. After that, it should be easy to slide the new grip on and adjust it to your preferences.

Visit      http://craigcurk.strikingly.com/      to know more.

Save

Advertisements

About Craig Curk

Craig Curk has been a youth soccer coach for over ten years. With a National “D” License, he has led his U-15 boys’ team to tenth place in the state cup championship in Bowling Green, Kentucky. He played Division I soccer at Xavier University while he was completing his BSBA in Accounting, but he never lost the desire to be involved with the sport.
This entry was posted in Craig Curk and tagged , , . Bookmark the permalink.